K1-828
PREMIUM FIBER REINFORCED WATERPROOF SLURRY
Premium Fiber Reinforced Waterproof Slurry is a single component / one part Ethylene-Vinyl Acetate modified waterproof coating that comprising of special cement based components, admixtures and fiberglass. This product is produced for direct application to a variety of construction substrates.
Details
- Fiberglass to enhance the tensile strength.
- Easy to use and apply.
- Good adhesion concrete and mortar substrates.
- Protects against water penetration.
- Low odor compared to bitumen coatings.
- Environmental friendly.
Technical Data
| Tools | Nylon / Polyester Brush, Sponge Paint Roller, Trowel |
| Drying Time | Touch Dry 1-2 Hours, Recoat 6-8 Hours (at 25°C) |
| Thickness | Wet 650 µm, Dry 400 µm |
| Available Sheen | Flat |
| Viscosity | 33,000-38,000 m.Pas at 25°C |
| Solid Content | 65%±2% |
| Available Size | 1 Gallon, 5 Gallon |
| Thinner | Water |
| Shelf Life | 24 months unopened condition |
| Color | 822 Black 827 Light Green 828 Gray |
Applications
Surface Preparation
- All new masonry, concrete, cement or block must be cured for 30 days at recommended.
- Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
- Product must be completely agitated (mechanically or manually) before use.
- Intermix containers of same product to ensure color and seen uniformity.
- Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
- Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
Downloads
Not all products are available online. Please contact your store or sales representative for more information.
| Datasheet | Adobe Reader Download |
|---|---|
| Safety Datasheet | Download |
| Product Datasheet | Download |
