K2-300
TWO COMPONENT ELASTIC WATERPROOF SLURRY
Two Component Elastic Waterproof Slurry is a two part Ethylene-Vinyl Acetate modified, ready-to-use liquid waterproofing compound which reacts with the constituents of cement and sand. This is the most suitable product for the waterproofing of masonry structures and mortar.
Details
- Reduced water absorption.
- Good adhesion with excellent workability.
- Protects against water penetration.
- Improved water-tightness.
- Non-toxic and chloride free.
Technical Data
Tools | Nylon / Polyester Brush, Sponge Paint Roller, Trowel |
Drying Time | Touch Dry 1-2 Hours, Recoat 6-8 Hours (at 25°C) |
Thickness | Thick Layer: Wet 1.2 mm, Dry 1 mm Thin Layer: Wet 580 µm, Dry 500 µm |
Availalbe Sheen | Flat |
Viscosity | 15,000-25,000 m.Pas at 25°C |
Solid Content | 55%±2% |
Available Size | 8:10kg Pack, 18:20kg Pack |
Thinner | Water |
Shelf Life | 24 months unopened condition |
Color | Milky White |
Applications
Surface Preparation
- All new masonry, concrete, cement or block must be cured for 30 days at recommended.
- Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
- Resin compound must be completely agitated (mechanically or manually) before use.
- Intermix the resin compound with aggregate (cement / sand) with ratio of 1:1.
- Intermix containers of same product to ensure color and seen uniformity.
- Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
- Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
Downloads
Not all products are available online. Please contact your store or sales representative for more information.
Datasheet | Adobe Reader Download |
---|---|
Safety Datasheet | Download |
Product Datasheet | Download |