Waterproof Slurry

K2-800

PC-CIDE TWO COMPONENT ELASTIC WATERPROOF SLURRY

PC-CIDE Two Component Elastic Waterproof Slurry is a two part Ethylene-Vinyl Acetate and Acrylic Acetate modified, ready-to-use liquid waterproofing compound which reacts with the constituents of cement and sand. This is the most suitable product for the waterproofing of masonry structures and mortar.

Recommend Uses

  • Concrete Block, CMU, Brick Stucco, Cement, Concrete Surface, Cement Composition Siding / Panel, Asbestos and Wood.
  • Interior and Exterior Wall, Swimming Pool, Pond, Bathroom, Kitchen, Window Siding / Panel, Balcony, Terrace and etc.

Coverage

  • 33m2 / (18:20kg Pack)
  • 17m2 / (8:10kg Pack)

Details

  • Ethylene-Vinyl Acetate and Acrylic Acetate modified compound.
  • Reduced water absorption.
  • Good adhesion with excellent workability.
  • Protects against water penetration.
  • Improved water-tightness.
  • Non-toxic and chloride free.

Technical Data

Tools Nylon / Polyester Brush, Sponge Paint Roller, Trowel
Drying Time Touch Dry 1-2 Hours, Recoat 6-8 Hours (at 25°C)
Thickness Thick Layer: Wet 1.2 mm, Dry 1 mm
Thin Layer: Wet 580 µm, Dry 500 µm
Available Sheen Flat
Viscosity 15,000-25,000 m.Pas at 25°C
Solid Content 55%±2%
Available Size 8:10kg Pack, 18:20kg Pack
Thinner Water
Shelf Life 24 months unopened condition
Color Milky White

Applications

Surface Preparation
  • All new masonry, concrete, cement or block must be cured for 30 days at recommended.
  • Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
Application Details
  • Resin compound must be completely agitated (mechanically or manually) before use.
  • Intermix the resin compound with aggregate (cement / sand) with ratio of 1:1.
  • Intermix containers of same product to ensure color and seen uniformity.
  • Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
  • Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.

Downloads

Not all products are available online. Please contact your store or sales representative for more information.

Datasheet Adobe Reader Download
Safety Datasheet Download
Product Datasheet Download

Contact Us

Your satisfaction is very important to us. If you have any question about our products or services, or any other comments and suggestions, please feel free to contact our customer team.