KC-077
CRYSTALLINE SILICATE PENETRATING WATERPROOF POWDER
This reactive penetrating product is a one part waterproof material that consist both organic and inorganic chemical components, quartz and concrete sand. The special chemical ingredient of crystalline silicate can easily react with the moist inside the concrete base, and further creates a cross-linking insoluble structure. The structure can be resist erosion of most salt, alkaline and salt water after Crystalline Silicate Penetrating Waterproof Powder is fully reacted on the surface.
使用範圍：
塗佈類型：
- Waterborne, environmental, odor-less and inflammable.
- Perfect to application on front and back of concrete structure surfaces.
- Perfect to application onto humid surface.
- Holes and cracks can be patched with size smaller than 0.4 mm.
- Excellent efflorescence, mold and mildew resistance.
- Excellent resistance to static water pressure.
| Tools | Hard Nylon Brush, Sponge Paint Roller, Sprayer |
| Drying Time | Fully Dry 7 Days (at 25°C) |
| Thickness | Dry 200 µm |
| Viscosity | Flat |
| Density | 1.5 kg/L |
| Viscosity | Solid |
| Solid Content | Solid |
| Available Size | 1 Gallon, 5 Gallon |
| Thinner | Water |
| Shelf Life | 36 months unopened condition |
| Color | Gray White |
Surface Preparation
- All new masonry, concrete, cement or block must be cured for 30 days at recommended.
- Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
- The application requires adequate pores on the surface for sufficient chemical penetration. If the surface is too smoothly, please use the high pressure water sprayer, spraying sand or other methods to roughen the surface for the best result.
- Product must be completely agitated (mechanically or manually) before use.
- Intermix Crystalline Silicate Penetrating Waterproof Powder to water with ratio of 3:1 or 2:1 (can be adjusted for the application easiness).
- Please apply the application within 30 minutes after the mixture has been completed.
- Application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
- Dilution is not recommended after the mixture has been completely reacted and hardened.
- Interior and exterior concrete surfaces.
- Concrete Block, CMU, Brick Stucco, Cement, Concrete Surface and Cement Composition Siding / Panel.
- Wall, Floor, Rooftop, Pond, Sewage Plant, Basement, Tunnel, Parking Lot, Swimming Pool and etc.
- 0.48-0.8 kg/m2 By Brush
- 0.48-0.64 kg/m2 By Sprayer
推薦產品 HOT PRODUCTS
K1-100
ULTIMATE MULTI...
K1-680
ULTIMATE ALL-P...
 |
 |
 |