K1-828

PREMIUM FIBER REINFORCED WATERPROOF SLURRY

Premium Fiber Reinforced Waterproof Slurry is a single component / one part Ethylene-Vinyl Acetate modified waterproof coating that comprising of special cement based components, admixtures and fiberglass. This product is produced for direct application to a variety of construction substrates.
使用範圍:
塗佈類型:
產品技術資料表 安全成份表
  • Fiberglass to enhance the tensile strength.
  • Easy to use and apply.
  • Good adhesion concrete and mortar substrates.
  • Protects against water penetration.
  • Low odor compared to bitumen coatings.
  • Environmental friendly.
Tools Nylon / Polyester Brush, Sponge Paint Roller, Trowel
Drying Time Touch Dry 1-2 Hours, Recoat 6-8 Hours (at 25°C)
Thickness Wet 650 µm, Dry 400 µm
Available Sheen Flat
Viscosity 33,000-38,000 m.Pas at 25°C
Solid Content 65%±2%
Available Size 1 Gallon, 5 Gallon
Thinner Water
Shelf Life 24 months unopened condition
Color 822 Black
827 Light Green
828 Gray
Surface Preparation
  • All new masonry, concrete, cement or block must be cured for 30 days at recommended.
  • Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
Application Details
  • Product must be completely agitated (mechanically or manually) before use.
  • Intermix containers of same product to ensure color and seen uniformity.
  • Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
  • Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
  • Concrete Block, CMU, Brick Stucco, Cement, Concrete Surface, Cement Composition Siding / Panel, Asbestos and Wood.
  • Interior and Exterior Wall, Pond, Bathroom, Kitchen, Window Siding / Panel, Balcony, Terrace and etc.
  • 5m2 Coverage per Gallon
推薦產品 HOT PRODUCTS