K1-868
SINGLE COMPONENT ELASTIC WATERPROOF SLURRY
Single Component Elastic Waterproof Slurry is a one part Ethylene-Vinyl Acetate modified waterproof coating that comprising of special cement based components and admixtures. This product is produced for direct application to a variety of construction substrates.
使用範圍：
塗佈類型：
- Easy to use and apply.
- Good adhesion with excellent workability.
- Protects against water penetration.
- Low odor compared to bitumen coatings.
- Economical.
| Tools | Nylon / Polyester Brush, Sponge Paint Roller, Trowel |
| Drying Time | Touch Dry 1-2 Hours, Recoat 6-8 Hours (at 25°C) |
| Thickness | Wet 650 µm, Dry 400 µm |
| Available Sheen | Flat |
| Viscosity | 33,000-38,000 m.Pas at 25°C |
| Solid Content | 65%±2% |
| Available Size | 1 Gallon, 5 Gallon |
| Thinner | Water |
| Shelf Life | 24 months unopened condition |
| Color | 865 Brown Yellow 868 Gray |
Surface Preparation
- All new masonry, concrete, cement or block must be cured for 30 days at recommended.
- Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
- Product must be completely agitated (mechanically or manually) before use.
- Intermix containers of same product to ensure color and seen uniformity.
- Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
- Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
- Concrete Block, CMU, Brick Stucco, Cement, Concrete Surface, Cement Composition Siding / Panel, Asbestos and Wood.
- Interior and Exterior Wall, Pond, Bathroom, Kitchen, Window Siding / Panel, Balcony, Terrace and etc.
- 5m2 Coverage per Gallon
推薦產品 HOT PRODUCTS
K1-100
ULTIMATE MULTI...
K1-680
ULTIMATE ALL-P...
 |
 |
 |