K1-206
HIGH GLOSS HEAT RESISTANT WATERPROOF PAINT
The concept of High Gloss Heat Resistant Waterproof Paint creates a high glossy, elastic thermal barrier which reflects heat once the paint / coating has dried. High Gloss Heat Resistant Waterproof Paint contains high quality titanium dioxide particles encased in a high-grade cross-linking acrylic emulsion. The thermal insulating coating that will reduces radiative and conducted heat to produce dramatic temperature differentials. High Gloss Heat Resistant Waterproof Paint is the top choice for a wide variety of thermal insulating paint and waterproofing applications on metal, concrete and wood surfaces.
使用範圍：
塗佈類型：
- Cross-linking emulsion increase dirt pickup resistance.
- Elastomeric coating.
- Moisture protection and heat dissipation.
- Crack-free coating flexibility that responds to substrate contraction / expansion.
- Cost-saving longevity. Energy efficiency for equipment and buildings.
- Easy application. No priming needed when apply on the metal surface.
| Tools | Nylon / Polyester Brush, Sponge Paint Roller, Sprayer |
| Drying Time | Touch Dry 1-2 Hours, Recoat 3-4 Hours (at 25°C) |
| Thickness | Wet 450 µm, Dry 200 µm |
| Available Sheen | Gloss |
| Viscosity | 9,000-11,000 m.Pas at 25°C |
| Solid Content | 50%±2% |
| Available Size | 5 Gallon |
| Thinner | Water |
| Shelf Life | 36 months unopened condition |
| Color | White |
Surface Preparation
- All new masonry, concrete, cement or block must be cured for 30 days at recommended.
- Remove all loose paint and defective paint if possible, oil, fluid, moss or other substances on the surface. In severe cases, wash the surface with water, make sure the surface is completely dried and clean. All holes cracks must be properly patched.
- Product must be completely agitated (mechanically or manually) before use.
- Intermix containers of same product to ensure color and seen uniformity.
- Dilution is not recommended. However if the dilution is required, do not dilute more than 10% of clean water.
- Priming and application of two coats at the recommended film thickness / practical coverage when application to new surfaces.
- Priming may not be needed when application on previously painted. Consult with your representative before application. Priming is no needed when application on the metal surface.
- Metal Surface (Shipping Containers, Factories, Accommodation Units, Electrical Cabinets).
- Concrete Block, CMU, Brick Stucco, Cement, Concrete Surface, Cement Composition Siding / Panel, Asbestos and Wood.
- 12m2 Coverage per Gallon
推薦產品 HOT PRODUCTS
K1-100
ULTIMATE MULTI...
K1-680
ULTIMATE ALL-P...
 |
 |
 |